Removing and installing components during servicing
Memory expansion
Your notebook has 256 Mb - 2 Gb of main memory installed, depending on the upgrade level. The
notebook will not start without memory modules, as no fixed main memory is installed.
Installing and removing the memory extension
If you are asked by the Hotline/Help Desk to remove and install the memory extension yourself,
proceed as follows:
Please take note of the safety information in the "Important notes" chapter.
!
The notebook must be switched off when installing/removing the memory modules, it
must not be in Suspend mode.
Use only memory expansions released for your notebook: 256, 512 MB and 1 GB DDR2-
533 SO DIMM (PC2-4200) module or 256, 512 MB or 1 GB DDR2-677 SO DIMM (PC2-
5300) module.
Never use force when installing or removing memory modules.
Make sure that foreign objects do not fall into the memory extension compartment.
A memory module is located under the service bay. You must open the service bay when removing
and installing a memory module. Once you have removed the cover, the various components are
exposed. These components should be removed and replaced only by authorised specialists.
Therefore, be sure to observe the following:
Individual components (e.g. the processor heat sink) can become very hot during
operation. Therefore, we recommend that you wait one hour after switching off the
notebook before removing or installing the memory modules. Otherwise, there is a danger
of being burned!
!
As some components with ESDs are exposed, please observe the section "Notes on
installing and removing boards and components" in the chapter "Important notes".
The second memory module cannot be accessed from outside and consequently may be removed or
replaced only by authorised service partners of Fujitsu Siemens Computers.
►
Switch the notebook off.
►
Close the LCD screen so that it locks into place.
►
Unplug the mains adapter from the mains socket.
►
Disconnect all cables connected to the notebook.
►
Place the notebook upside down on a flat surface.
►
Remove the battery (see "Removing battery").
54
10600736497, edition 3
Summary of Contents for AMILO Si 1848
