錯誤
!
尚未定義樣式。
A26391-Kyyy-Z120-1-7619
31
Operating systems with APM (Windows 95, Windows NT with APM
extensions)
i
For operating systems with APM (Advanced Power Management) you can set the energy-
saving functions in the
BIOS Setup
(e.g.
Suspend to RAM
,
Save to Disk
,
LCD off
etc.).
Setting energy-saving modes
Ê
Call the
BIOS Setup
.
Ê
Set which energy-saving mode you want to use in the
Power
menu.
Ê
Set the
Auto Suspend Timeout
parameter in the
Power
menu to a time period after which the
notebook is to be switched into the energy-saving mode.
Suspend to DRAM
In this mode the current data in the main memory (DRAM) is stored. The data is stored for as long as
the notebook is supplied with energy. If the battery is full, the data is stored for a matter of days.
Without a battery and without a power supply the current data is lost.
Save to Disk
So that the current data can be saved, sufficient memory must be available on the hard disk. If the
operating system Windows NT or OS/2 Warp is used, a Save-to-Disk partition must be created on the
hard disk (see manual for respective operating system).
In this case also see the section "PHDISK (for Windows 98 and Windows NT only)".
PHDISK (for Windows 98 and Windows NT only)
The
PHDISK
service programme reserves the memory space required for the use of Save-to-Disk
mode. The programme creates a file or partition for saving the main memory contents and the system
register when your notebook is switched over to Save-to-Disk mode. The positions of the first and last
free sectors are saved in the CMOS after running this programme.
•
Run
PHDISK
after you have installed or removed memory modules.
•
Run
PHDISK
after you have installed or restored Windows 98.
•
Run
PHDISK
after you have replaced your hard disk.
•
Run
PHDISK
if you have received a BIOS error message in conjunction with Save-to-Disk mode
during the self test (POST).
i
In Windows NT the
PHDISK
service programme is not supported by the NTFS file system.
In Windows 2000/ME the required memory space on the hard disk is not reserved until you
make the required Hibernate mode settings under
Settings - Control Panel - Power
Management.
Running PHDISK
Ê
Click on
Start
and then
Shut down
in Windows.
Ê
Activate the
Start computer in MS-DOS mode
checkbox and click on
Yes
.
Summary of Contents for CELSIUS H
