Preparation for use and operation
Workstation battery
22
A26391-K82-Z110-1-7619
Workstation battery
The workstation is fitted with a battery (Lithium Ion battery) that provides it with power during mobile
use. You can increase battery life by enabling the system's power management features.
In addition to the workstation standard battery, you can also use a second workstation battery. By
using both workstation batteries, you can double the workstation's mobile operation time.
The workstation battery charge is indicated by the battery symbol in the display field (see chapter
"
"). When you switch on the workstation, it takes a few seconds before
the battery status is displayed.
The battery will last for roughly 500 charge/discharge cycles.
i
To utilize the optimum charging capacity of the battery, you should regularly perform the
battery learning cycle (see chapter "
Learning cycle for workstation batteries
").
Charging, caring for and maintaining the workstation battery
!
Only use workstation batteries designed for this workstation.
The workstation battery can only be charged, when the ambient temperature is between 5°C and
max. 40°C.
The workstation battery charge is indicated by the battery symbol in the display field.
A workstation battery will fully charge in approximately three hours in a workstation that is switched
off. After half the charging time, the battery has already reached a 70 % charge level. A workstation
battery will fully charge in approximately four hours if the workstation is switched on. If the
workstation is fitted with two workstation batteries, charging will take twice as long. The workstation
batteries are charged successively. The battery which was connected first is charged first.
The workstation battery can be charged by:
•
connecting the workstation to the power adapter
•
connecting the workstation to the car adapter
•
connecting the workstation to the QuickPort S
Before a workstation battery is used for the first time, the battery learning cycle should be performed
(see also the section "
Learning cycle for workstation batteries
").
Work in the battery mode until an acoustic warning signal indicates the need for charging. The
workstation battery should not be charged before this point.
i
If you do not use the workstation batteries for an extended period of time, remove them
from the workstation. Never store the workstation batteries in the unit.
If storing for a long period of time (longer than two months), workstation batteries should be stored
in a charged state of approximately 50%. After six months, at the latest, you should run a learning
cycle with the batteries again. If you store the batteries up to two months, the charge status of the
batteries must be approximately 30%. The workstation batteries should be stored in a dry
environment in temperatures b10°C and +25°C.
Summary of Contents for CELSIUS MOBILE 810
Page 3: ......
Page 9: ...Contents A26391 K82 Z110 1 7619 Port for external monitor 63 Parallel port 63 Index 65...
Page 50: ......
Page 60: ......
