Using the power-management features
Preparation for use and operation
A26391-K82-Z110-1-7619
37
Suspend mode
In suspend mode, all current data (active programs, files) is buffered in the memory (
Suspend
) or
saved to the hard disk (
Suspend to Disk
), and then the workstation is switched off. After the
workstation is switched on, you can continue working exactly where you left off before.
i
The Suspend mode is shown in the display field with the display
.
Enabling Suspend mode
[Fn]
[Fn]
[Fn]
[Fn]
+
[F4]
[F4]
[F4]
[F4]
!
If your workstation is in Suspend mode:
•
do not connect any external peripheral devices
•
do not disconnect any external peripheral devices
•
do not attempt to switch it on if the built-in battery is flat
•
do not change or remove the floppy disk, if inserted
•
do not add or remove RAM
•
do not add or remove any PC cards.
Suspend (to DRAM)
The current data is buffered in the memory (DRAM). The data is stored for as long as the
workstation is supplied with energy. If the workstation battery is full, the data is stored for a matter of
days. Without a battery and without a power supply the data is stored for only about 5 minutes.
Ê
Set
Power Setup - Suspend Mode
field in the
BIOS setup
to
Suspend
.
Suspend to Disk
The active data can only be saved if sufficient space is available on the hard disk (at least the main
memory size + 2 Mbytes). To ensure this is so, in Windows NT you must set up a FAT partition
providing this space as drive C: on the hard disk (see the operating system manual).
Ê
In the
BIOS Setup
menu set the
Power Setup - Suspend Mode
field to
Save to Disk
.
Ending Suspend mode
Ê
Switch the workstation on.
The workstation reverts to the status it had prior to switching into Suspend mode.
Automatic activation
If the workstation is running and is not used for a predefined period of time, it switches into Suspend
mode.
Ê
In the
Power Setup
menu set the
Power Setup - Power Savings
field to
Customize
and set the time
which has to elapse before the workstation switches to Suspend mode in the
Suspend Timeout
field.
Ê
In the
BIOS Setup
menu set the
Power Setup - Suspend Mode
field to
Save to Disk
or
Suspend
.
or
Ê
In the
BIOS Setup
menu set the
Power Setup - Power Savings
field to
Maximum Performance
or
Maximum Power Savings.
Ê
In the
BIOS Setup
menu set the
Power Setup - Suspend Mode
field to
Save to Disk
or
Suspend
.
Summary of Contents for CELSIUS MOBILE 810
Page 3: ......
Page 9: ...Contents A26391 K82 Z110 1 7619 Port for external monitor 63 Parallel port 63 Index 65...
Page 50: ......
Page 60: ......
