Preparing the notebook for use
10600648445, edition 1
13
►
Connect the mains adapter cable (1) to the DC jack (DC IN) of the notebook.
►
Connect the power cable (2) into the mains adapter.
►
Plug the power cable (3) into a mains outlet.
Switching on the notebook for the first time
!
When you switch on your notebook for the first time, the supplied software is installed and
configured. Due to the fact that this installation must not be interrupted, you should set
aside enough time for it to be fully completed and connect the notebook to the mains outlet
using the mains adapter.
During installation, the notebook may only be rebooted when you are requested to do so!
Your operating system is pre-installed on the hard disk to facilitate the procedure when you use your
notebook for the first time.
►
Switch the notebook on (see "Using your notebook" chapter, "Switching on the notebook"
section).
►
During installation, follow the instructions on screen.
Consult the operating system manual if there is anything unclear about the requested input data.
i
If there is a Windows operating system installed on your notebook the "Drivers°&°Utilities"
CD/DVD is included in the delivery scope. You will find further information on the system,
drivers, utilities, updates, manuals etc. on this "Drivers & Utilities" CD/DVD.