C o n f i g u r i n g Y o u r L i f e B o o k 4 0 0 S e r i e s
L i f e B o o k 4 0 0 S e r i e s f r o m F u j i t s u
73
Get Default Values:
Sel ecting G et Default Va lu e s wi ll load the factory
pre s et default va lues for all menu fiel d s . Wh en
the load is com p l ete the Setup Uti l i ty wi ll dis-
p l ay the message
Default values have
been loaded.[Continue]
. Wh en any key is
pre s s ed the Setup Uti l i ty wi ll retu rn to the Ex i t
Menu. To retu rn to another menu fo ll ow the
d i recti ons in the Navi ga ting Th ro u gh The Setu p
Uti l i ty Secti on . (See pa ge 46.)
Load Previous Values:
Sel ecting Load Previous Va lues wi ll load the
BIOS mem ory va lues for all menu fiel d s . Wh en
the load is com p l ete , the Setup Uti l i ty wi ll dis-
p l ay the message
Previous values have
been loaded [Continue]
. Wh en any key is
pre s s ed the Setup Uti l i ty wi ll retu rn to the Ex i t
Menu . To retu rn to another menu , fo ll ow the
d i recti ons in the Navi ga ting Th ro u gh The Setu p
Uti l i ty Secti on . (See pa ge 46. )
Save Changes:
Selecting Save Changes will cause the new
settings in all menus to be written to the
BIOS memory. When saving is complete the
message
Changes have been saved
[Continue]
will be displayed. Pressing a
key will return the Setup Utility to the Exit
Menu. To return to another menu, follow the
directions in the Navigating Through The
Setup Utility Section. (See page 46.)
Setting Up Your Save-To-Disk
File Allocation
Your notebook comes with an allocation of
space on the internal hard drive adequate to
operate the Save-to-Disk function for the
amount of memory installed at the factory.
If you add a RAM Module or do not use the
Save-to-Disk function and wish to free up the
disk space you will need to change the alloca-
tion. The utility to change the allocations is
PHDISK.EXE and is activated from the
MS-DOS prompt.
PHDISK allows you to perform five di
ff
erent
functions related to the Save-to-Disk space on
the internal hard drive. They are:
1. All oc a te a space for the Save - to - Disk functi on .
2. Remove all space allocation for the Save-to-
Disk function.
3.Find out details about the hard drive and the
current Save-to-Disk space allocation.
4. Re-allocate space and mark bad blocks in the
space allocated to the Save-to-Disk function
when a disk error has occurred.
5. Find out how mu ch space is needed to perform
the Save - to - Disk functi on with the curren t
m em ory con fig u ra ti on and how mu ch unu s ed
s p ace is ava i l a ble on the internal hard drive .
To find out how much space is needed to per-
form the Save-to-Disk function with the cur-
rent memory configuration and how much
unused space is available on the internal hard
drive, do the following:
1.Go to the MS-DOS prompt.
(In Windows 95 go to the Start Menu and
select MS-DOS Prompt.)
2. Type
CD C:\Fujitsu
Summary of Contents for 420D
Page 3: ...T a b l e o f C o n t e n t s ...
Page 149: ...I n d e x ...
