40
Important
•
When you do not install an additional memory module in BANK2, insert the continuity module
into it. When BANK2 has no module installed, the PC does not operate properly.
•
The continuity module is not used on computers equipped with an additional memory module
in BANK2 as a custom-made option. Therefore, memory combinations using the C-RIMM
shown in the table cannot be chosen on such computers.
•
Be sure to install memory modules of the same size to a combination of RIMM2 and RIMM3
and a combination of RIMM2 and RIMM4.
■
Installing/removing memory modules
Here, procedures for installing and removing memory modules are explained with an example of
replacement of the continuity module in RIMM1 with a memory module.
Point
•
In installing or removing a continuity or memory module, hold the PC unit to prevent it from
falling. Work will be easier on a PC in a horizontal position.
•
A front access bay with a device installed may prevent you from installing and removing memory
modules with ease. In that event, remove the PC cover after carrying out Step 3 in “Installing
memory modules” and then remove the screws from the front access bay to slide the device
toward the front of your PC.
•
When returning the device back into the front access bay, use care not to allow it to touch the
memory modules.
06-DP8 (34-42)
3/2/01, 2:32 PM
40
Summary of Contents for 8000 SERIES
Page 14: ...4 Back of the PC unit 14 1 2 3 4 5 6 7 8 9 10 11 12 13 ...
Page 66: ...56 ...
Page 70: ...60 ...
