Installing the Printer
6. Assembling Pedestal and Bin-feeder
Printer, Bin feeder and Pedestal are assembled through four steps as following
1
st
step: Moving casters to the pedestal from stand bin,
2
nd
step: Adjusting height of the pedestal to fit a counter height
3
rd
step: Mounting the bin-feeder and the printer.
4
th
step: Mounting F9811 printer
1
st
step: Moving caster
1. Move four casters to bottom of the pedestal from
the bin feeder. Refer to photo 1,2.
Please use the same screws which are used
on the stand bin.
2
nd
step: Adjusting the pedestal height
Shift down both side frames after removing the
screws, and fix them again so that positioning dowels
meet the positioning holes at expected height.
4 kinds of height are selected as below drawing 1.
Photo 2
Bin feeder
Ball Casters
Pedestal
Photo 1
15 cm
Drawing 1
20 cm
Screws
25 cm
Lower side frames
Middle side frames
Upper side frames
30 cm
Photo 3
Rear bar
Front bar
15 cm
20 cm
25 cm
30 cm
Photo 4
Drawing 2
Positioning Dowels
Upper frames
Middle frames
Lower frames
Positioning Holes
Positioning Holes
Positioning Dowels
Screws
15
Summary of Contents for 9811 ATB
Page 22: ...printed in Japan ...