En-7
To Select Mode Operation
1
Press the START/STOP button (Fig.5
O
).
The indoor unit’s OPERATION Indicator Lamp (green) (Fig. 3
6
) will light.
The air conditioner will start operating.
2
Press the MODE button (Fig.5
I
) to select the de-
sired mode.
Each time the button is pressed, the mode will change in the following order.
AUTO
COOL
DRY
HEAT
FAN
About 3 seconds later, the entire display will reappear.
To Set the Thermostat
Press the SET TEMP. button (Fig. 5
P
).
button:
Press to raise the thermostat setting.
button:
Press to lower the thermostat setting.
●
Thermostat setting range:
AUTO
....................................18-30
°C
Cooling/Dry
...........................18-30
°C
Heating
..................................16-30 °C
The thermostat cannot be used to set room temperature during the FAN mode (the tem-
perature will not appear on the Remote controller’s Display).
About 3 seconds later, the entire display will reappear.
The thermostat setting should be considered a standard value, and may differ
somewhat from the actual room temperature.
To Set the Fan Speed
Press the FAN button (Fig. 5
N
).
Each time the button is pressed, the fan speed changes in the following order:
AUTO
HIGH
MED
LOW
QUIET
About 3 seconds later, the entire display will reappear.
When set to AUTO:
Heating :
Fan operates so as to optimally circulate warmed air.
However, the fan will operate at very low speed when the temperature of
the air issued from the indoor unit is low.
Cooling :
As the room temperature approaches that of the thermostat setting, the
fan speed becomes slower.
Fan
:
The fan runs at the low fan speed.
The fan will operate at a very low setting during Monitor operation and at the
start of the Heating mode.
SUPER QUIET Operation
SUPER QUIET operation begins. The indoor unit’s air
fl
ow will be reduced for quieter
operation.
●
SUPER QUIET operation cannot be used during Dry mode. (The same is true when
dry mode is selected during AUTO mode operation.)
●
During Super Quiet operation, Heating and Cooling performance will be reduced
somewhat. If the room does not warm up/ cool down when using SUPER QUIET Op-
eration, please adjust the air conditioner’s Fan Speed.
OPERATION
Example:
When set to COOL.
Example:
When set to 26 °C.
Example:
When set to AUTO.
▲
▲
▲
▲
▲
▲
▲
▲
▼
▼
9378532045_OM.indb 7
9378532045_OM.indb 7
9/28/2011 4:21:42 PM
9/28/2011 4:21:42 PM
