En-2
PREPARATORY OPERATION
Instructions relating to heating are applicable only to “HEAT & COOL MODEL” (Reverse Cycle).
Set the current day and time
Press for 3 seconds.
Select the number that corresponds to
the current day indicated by a code from
1 to 7.
1
2
Press repeatedly to adjust the current
time in 1-minute increments. Press con-
tinuously to adjust the current time in 10-
minute increments.
Press again to end.
3
4
Day code
1
2
3
4
5
6
7
Day of the
Mon Tue Wed Thu Fri Sat Sun
week
To start/stop operation
Start time: Operation lamp will light up.
Stop time: Operation lamp will go out.
Operation mode setting
→
AUTO
→
COOL
→
DRY
→
FAN
→
HEAT
NOTES
To set the operation mode
(1)
• Always use the remote controller’s AIRFLOW DIRECTION button.
Attempting to move the air direction louvers manually could re-
sult in improper operation; in this case, stop operation and re-
start.
The flaps should begin to operate properly again.
• During use of the Cooling mode, do not set the VERTICAL air
direction flap in the
4
position for long time, since water vapor
may condense near the outlet port and drops of water may drip
from the air conditioner.
(2)
• The range of swing is relative to the currently set airflow direc-
tion.
• The SWING operation may stop temporarily when the air condi-
tioner’s fan is not operating, or when operating at very low speeds.
<Vertical airflow swing operation>
Airflow direction
Range of swing
1
1
to
3
2
2
to
4
3
2
to
4
4
1
to
4
(All range)
<Horizontal airflow swing operation>
Airflow direction
Range of swing
1
1
to
5
(All range)
2
1
to
3
3
2
to
4
4
3
to
5
5
1
to
5
(All range)
Fan speed setting
Room temperature setting
Vertical air direction adjustment (1)(2) (Swing operation)
Horizontal air direction adjustment (2) (Swing operation)
* Press the START/STOP button to start the air conditioner,
and then proceed as follows.
To set the swing operation, press the VERTICAL
SWING button for more than 2 seconds. (Stop
the setting by pressing for more than 2 seconds
again.)
To set the swing operation, press the HORIZON-
TAL SWING button for more than 2 seconds.
(Stop the setting by pressing for more than 2
seconds again.)
Temperature setting range:
AUTO ....................................................... 18 to 30
°
C
Heating .................................................... 16 to 30
°
C
Cooling/Dry ............................................. 18 to 30
°
C
1
2
3
4
1
2
3
4
5
→
AUTO
→
HIGH
→
MED
→
LOW
Energy save setting
Anti freeze setting
Stop the “ENERGY SAVE” setting by pressing
the ENERGY SAVE button again.
Press at the same time for more than 3 seconds.
Stop the “ANTI FREEZE” setting by pressing
at the same time for more than 3 sec-
onds again.
* Press the START/STOP button to stop the air conditioner,
and then proceed as follows.
1
2
3
4
1 2
3
4 5
OPERATION
Instructions relating to heating are applicable only to “HEAT & COOL MODEL” (Reverse Cycle).
* Press the START/STOP button to start the air conditioner,
and then proceed as follows.
