Connecting external devices
Connecting an external SATA hard disk (eSATA)
An external SATA hard disk can be connected at the eSATA/USB combination port. This allows you to
expand the internal hard disk capacity as you wish. You should obtain a hard disk with a robust casing.
The cable is not included in the delivery scope. It can be obtained through your
retailer. The length of the eSATA cable must not exceed 2 metres. Simple SATA
cables are designed for installation in devices and cannot be used due to the
differences in pin allocation. Please consult a specialist retailer for advice.
The data transfer rate is up to 2,400 Mbit/s.
eSATA
►
Connect the data cable to the external
device.
►
Connect the data cable to the eSATA/USB
combination port of the computer.
Device driver
The eSATA hard disk is automatically recognised by your operating system and installed.
You will
fi
nd more information in the documentation for the external SATA
hard disk and the operating system.
Safe removal of eSATA and USB devices
In order to protect your data, always follow the correct procedure
for removing the device outlined below.
►
Left-click on the icon.
►
Select the device you want to stop and remove.
►
Press the Enter key.
Wait for the dialogue box which tells you that it is now safe to remove the device.
A26391-K90-Z200-1-7619, edition 1
59
Summary of Contents for AMILO M Series
Page 1: ...Operating Manual English AMILO Notebook ...
Page 3: ......