44
Critical Point
To check the memory size after you have replaced a memory, check the memory slot indication
which is displayed in the Information menu of the BIOS Setup Utility. Memory size is displayed
for example: 64MB SDRAM. If your PC doesn’t start up even if the memory is properly installed,
the RAM Expansion Module should be faulty or have a defect. In this case, contact Fujitsu
Service Center or the retailer from which you have purchased your PC.
If you want to expand the memory, replace the pre-installed memory at the shipping with
larger capacity one.
Always make sure to install a memory before turn on the power to the PC.
Make sure not to drop small parts you removed such as screws inside the PC body, as it may
cause a PC failure.
1
Turn off the power to the PC and disconnect the AC adapter.
2
Close the LCD Display and turn your PC bottom side up.
4
Remove the memory.
Slot Cover
3
Unscrew the screw and remove the RAM
Expansion Module Slot Cover.
Remove the RAM Expansion Module Slot
Cover on the bottom side of the PC.
Memory
Module
Clip
Pull clips sideways from each side of the
memory and remove the memory module.
Quilt Sec 2_34-47
17/10/2000, 15:37
44
Summary of Contents for b2178
Page 43: ...33 SECTION 1 ...
Page 70: ...60 ...
