BACnet
®
Gateway for VRF System
INSTRUCTION MANUAL r1.3.2 eng
96/103
Copyright© 2010-2017 Fujitsu General Limited - All rights reserved
Diagnostic
Use this setting to check the current communication status of the gateway on both: BACnet and FGL.
Communication with the box, the BACnet side and the Fujitsu system can be check using the viewer available.
Figure 8.12
Diagnostic tool
1. Hardware Test:
Checks the current hardware status of the gateway to ensure that is not faulty.
2. Log:
Enables the LOG Record Mode which starts loggin communications from all viewers and stores it in
a zip file. This file can be sent directly to the support team to check any unexpected behavior of the box.
3. Commands:
It sends specific commands to the gateway to perform general actions.
•
INFO?
Asks the gateway to identify itself and show basic information.
•
RESET!
Resets the gateway. This is not a back to factory settings action.
•
Enable COMMS
Enables communication between the gateway and the Configuration Tool
•
Disable COMMS
Disanables communication between the gateway and the Configuration Tool
8.7.1 Console
Shows basic information about the gateway and communication between BACnet and VRF systems.
8.7.2 BACnet Server Viewer
Shows specific information about the BACnet communication.
8.7.3 Fujitsu VRF Viewer
Shows specific information about the VRF network communication.