Page 3 of 52
Information on the installation and removal of components
Please pay attention to the locking mechanism (indentations and centring pins) when installing hardware components.
Note that some components on the mainboard may be very hot if the device was in use shortly before the case was removed.
Utmost care is required during installation and removal to avoid damaging components.
Never use items with sharp edges (screwdrivers) to lever them out.
Parts with Electrostatic Sensitive Devices (ESD) can be identified by a corresponding label.
When dealing with boards with ESDs, the following points must always be observed:
■
Always ensure there is a static discharge (e.g. by touching a grounded object)
prior to commencing with the work.
■
The devices and tools being used must not be statically charged.
■
Only touch the components along the edges or on the areas marked in green
(contact points).
■
Contacts and electronic components must not touch when handling components
equipped with ESD protection.
Summary of Contents for CELSIUS H7510
