Connecting external devices
66
A26391-K124-Z100-1-7619
Operating workstation with docking device
The "Port Replicator II-L" instantly turns your device into a convenient, easy-to-operate workstation.
For additional information on the Port Replicator II-L, also see the documentation on the docking
devices.
i
You should install your workstation's software (operating system, device drivers) before
docking the workstation the first time.
Connections for external devices on the Port Replicator II-L
The ports for external devices are on the rear of the port replicator II-L. The standard ports are
indicated by symbols.
i
The serial, parallel and audio ports can be configured in the
BIOS Setup
of the workstation.
Some of the devices that you connect require special drivers (e.g. a printer driver for the
printer). For information on which driver you need to install and where, please refer to the
documentation for the device concerned.
The following illustration shows the positions of the connections on the II-L port replicator.
1 2 3 4
6
5
7
1211 10
8
9
1 = DC jack (DC IN)
2 = PS/2 mouse port
3 = PS/2 keyboard port
4 = Serial port
5 = Parallel port
6 = Two USB ports
7 = Monitor port (VGA)
8 = LAN connector (network)
9 = Connection for floppy disk drive adapter
10 =
Audio input (Line-In)
11 =
Microphone connector
12 =
Audio output (Line-Out, analogue)
