Step 3
Slide the sub-assembly enclosure back to expose the optical fibers.
Step 4
Disconnect the optical fibers from the SFP module.
Step 5
Add protective covers to the optical fibers.
Step 6
Insert protective covers to both mating connectors.
✓
This task is complete.
7.1.5
Remove SFP Module
This procedure describes how to remove the SFP module from the RU.
Prerequisite:
■
RU powered off
Danger:
Use properly insulated tools and perform all safety
precautions in accordance with local safety practices when working
on or around power terminals, power cables, and power connectors.
Contacting power terminals, uninsulated conductors, cable wiring,
or any connector that could be part of a live electrical circuit can
result in death or serious personal injury.
Danger:
Utilisez des outils correctement isolés et appliquez toutes
les précautions de sécurité conformément à la sécurité locale
pratiques lorsque vous travaillez sur ou autour des bornes
d'alimentation, des câbles d'alimentation et des connecteurs
d'alimentation. Contacter bornes d'alimentation, conducteurs non
isolés, câblage de câbles ou tout connecteur pouvant faire partie
d'un un circuit électrique peut entraîner la mort ou des blessures
graves.
Step 1
Locate the SFP in the eCPRI port on the RU.
Step 2
Lift the lever on the SFP.
Step 3
Pull the SFP out of the eCPRI port.
Step 4
Apply a protective cover to the eCPRI port.
Removal
Cable Removal
154
Release 1.0
·
Issue 1.1, May 2021
Fujitsu and Fujitsu Customer Use Only