Fujitsu E Series User Manual Download

Page: 39 / 122

L i f e B o o k E S e r i e s – S e c t i o n T w o

Setting Passwords

When shipped from the factory, no passwords are set.
You have a choice of setting no password or supervisor
and user password. Once a password is set, the notebook
requires the password whenever turning on the note-
book or resuming from a suspend state. When setting
two passwords, the supervisor password is set before
the user password. When setting only one password,
it has to be the supervisor password.

Setting Supervisor Password

You must have set a supervisor password prior to setting
any user passwords. The supervisor password can bypass
the user password.

1. Go to the Start menu.

2. Click on Run.

3. Type in

FJSECS.exe

, then press [Enter]

4. Follow the on-screen instructions to set the

Supervisor password.

Setting User Password

1 Go to the Start menu.

2. Click on Programs.

3. Click on Security Panel Application and

Set User Password.

4. Follow the on-screen instructions to set the

User password.

OPERATING YOUR LIFEBOOK SECURITY
APPLICATION PANEL

The security lock feature is in effect both when the system
resumes from OFF or suspend state. You would always
need to push the suspend /resume key to input the user
password. Your system would not begin the boot sequence
without entering your supervisor/user Password

From Off State

1. Turn on your system.

2. When lock lamp lights up, enter the password and

press [Enter].
For example, if the password is 22222,
Press Button Number 2 five times and press [Enter].

3. The notebook will boot to normal operation.

From Suspend State

1. Press your Suspend/Resume button.

2. When lock lamp lights up, enter the password and

press [Enter].

3. The notebook should resume normal operation.

Incorrect Password Entry

If an invalid supervisor or user password is entered three
times in succession, the system will “beep” for about 1
minute. If a valid password is entered within a minute
(while system beeps), the beeping will stop and the note-
book will resume normal operation. If no or invalid
password is entered while the system beeps, the system
will return to it’s previous locked state (suspend or off)
and the Lock lamp will go off. To reactivate the notebook
after a password failure, you must press the Suspend/
Resume button, then enter a correct password.

Ring Wake-up, Wake-on-LAN, and Timer Resume

Your notebook may be set to wake-up when receiving a
telephone call (if attached to a modem and telephone
line), signal from a LAN, or at a designated time. To
enable these functions refer to your User’s Guide.

This security function can work only after pushing
suspend/resume button. When the system wakes up
by Ring Wake-up, Wake-ON-LAN, and Timer resume
function, the security function does not work.

P O I N T

You have to set both the supervisor and user passwords
for the security panel to work.

P O I N T

You may change or remove the supervisor or user pass-
word by repeating the steps defined above.

W A R N I N G

Remember the user password you specified on the
Security Panel Application. If you forget the password
you will not be able to use your computer. The supervi-
sor password can override the user password.