Appendix C Setting Procedures for Replacing HBAs
C.4 Required Storage System Settings After HBA Replacement (When Host Affinity Settings are Used)
ETERNUS Web GUI User’s Guide (Operation)
Copyright 2016 FUJITSU LIMITED
P2X0-1260-19ENZ0
418
C.4
Required Storage System Settings After HBA Replacement
(When Host Affinity Settings are Used)
In this section, the setting procedure for an ETERNUS DX/AF that uses host affinity settings is provided.
The procedure for storage system settings when the host affinity is used is as follows.
Change the WWN of the HBA that is to be replaced to the WWN of the new HBA.
Procedure
1
Input "User ID" and "Password" in the browser and log in to ETERNUS Web GUI.
•
When management software such as ETERNUS SF Storage Cruiser is used, use the management software
for migrating the current access path settings instead of the procedure that is provided in this manual
(manual setting).
•
To set WWN zoning by using the switch, make sure to change the zoning settings in advance.
Summary of Contents for ETERNUS AF250
Page 2: ...This page is intentionally left blank ...
Page 423: ......
