Chapter 3 Configuration Settings and Display
3.3 RAID Group Management > create eco-schedule
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED
P2X0-1030-09ENZ0
131
create eco-schedule
An ECO schedule is a schedule that applies ECO functions. The ECO schedule specifies the time that a disk
motor is rotated (it does NOT specify when the motor will be turned off). A maximum of 64 ECO schedules can
be created. One ECO schedule consists of a maximum of 8 ECO schedule events (at least one ECO schedule
event is required in one ECO schedule). This command can create one ECO schedule and only one ECO
schedule event. If two or more ECO schedule events are created and defined, use the "set eco-schedule"
command. Refer to the following:
■
Syntax
■
Parameter
Max 64
...
ECO Schedule
ECO Schedule
Schedule-Event #1
Schedule-Event #7
Schedule-Event #8
Schedule-Event #5
Schedule-Event #6
Schedule-Event #2
Schedule-Event #3
Schedule-Event #4
create eco-schedule -name
schedule_name
-event-type {every-day |
every-week,{mon|tue|wed|thu|fri|sat|sun},{mon|tue|wed|thu|fri|sat|sun} | specific-day,
MMDD
,
R
|
specific-week,
MM
,{1st|2nd|3rd|4th|last},{mon|tue|wed|thu|fri|sat|sun},{mon|tue|wed|thu|fri|sat|sun}}
-event-from
hhmm
-event-to
hhmm
-name
This parameter specifies the ECO schedule name. Only one ECO schedule name can be
specified. For details, refer to
"1.2.13 ECO Schedule Syntax" (page 25)
.
-event-type This parameter specifies the ECO schedule event type.
every-day
The ECO schedule is applied to every day. A suboperand is not required.
Example: -event-type every-day
every-week The ECO schedule is applied to every week. This format is "every-week,STA,END".
The start day of the week (STA) and the end day of the week (END) are separated
by a comma. The day of the week must be specified in the following format. The
end day of the week must be after the start day of the week. The first day starts
from Monday.
Summary of Contents for Eternus DX410 S2
Page 2: ...This page is intentionally left blank ...
Page 756: ......
