Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > copy mapping
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED
P2X0-1030-09ENZ0
286
copy mapping
This command copies the mapping definition from one specified host interface port to others. This command
cannot be used when Host Affinity Mode for the host interface port is enabled.
■
Syntax
■
Parameter
■
Example(s)
copy mapping -source-port {
xyz
} -destination-port {
xyz
|all}
-source-port This parameter specifies the host interface port of the copy source. Only one parameter can be
specified at the same time.
Example: -source-port 000
For details, refer to
"1.2.14 Host Interface Port Syntax" (page 25)
.
xyz
"x" is the controller module (CM) number, "y" is the CA number, and "z" is the host port
number.
Example: "123" indicates CM#1-CA#2-Host port#3
-destination-port
This parameter specifies the host interface ports to be released. Two or more parameters can
be specified by separating them with a comma.
Example: -destination-port 000,100
For details, refer to
"1.2.14 Host Interface Port Syntax" (page 25)
.
If "all" is selected, all of the host interface ports will be changed.
xyz
"x" is the controller module (CM) number, "y" is the CA number, and "z" is the host port
number.
Example: "123" indicates CM#1-CA#2-Host port#3
all
All the host interface ports
The following example copies the mapping definition from host interface port #0 on CM#0 CA#0 to host
interface port #0 on CM#1 CA#0:
CLI> copy mapping -source-port 000 -destination-port 100
The following example copies the mapping definition from host interface port #0 on CM#0 CA#0 to host
interface ports #0 and #1 on CM#1 CA#1:
CLI> copy mapping -source-port 000 -destination-port 110,111
Summary of Contents for Eternus DX410 S2
Page 2: ...This page is intentionally left blank ...
Page 756: ......
