Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > set port-group
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED
P2X0-1030-09ENZ0
312
set port-group
This command changes the port group name, adds ports to port groups, and deletes ports from port groups.
■
Syntax
■
Parameter
•
A port can be added to a port group even when this makes the ports that belong to this port group
identical to the ports of another existing port group.
•
A port can be added even when mapping is already set for the port in a different group.
•
A port can be added to or deleted from a port group for which mapping is set.
•
When a port is deleted from a port group, the mapping information for the port is deleted (the
information when the port belongs to the port group is not retained).
•
A port cannot be deleted from a port group when no ports belong to the port group after the port is
deleted.
•
After a port is deleted from a port group, the port group might not have any logical paths. In this case, the
mapping setting between port groups must be also deleted.
•
Up to eight ports can be set for a single port group.
set port-group { -port-group-number
port_group_number
| -port-group-name
port_group_name
}
[-name
port_group_name
] [-add-port
ports
| -release-port
ports
]
-port-group-number
or
-port-group-name
This parameter specifies the port group identifier to be changed. Only one port group can be
specified at the same time. For details, refer to
"1.2.15 Port Group Syntax" (page 26)
-name
Optional. This parameter specifies the new port group name. Only one name can be specified
at the same time. If omitted, the existing setting is not changed. For details, refer to
.
-add-port
or
-release-port
Optional. This parameter specifies the host interface port that is to be added or deleted. Two or
more parameters can be specified by separating them with a comma.
Example: -add-port 000, 011
For details, refer to
"1.2.14 Host Interface Port Syntax" (page 25)
.
xyz
"x" is the controller module (CM) number, "y" is the CA number, and "z" is the port
number.
Example: "123" indicates CM#1-CA#2-Port#3
Summary of Contents for Eternus DX410 S2
Page 2: ...This page is intentionally left blank ...
Page 756: ......
