Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > show host-lu-qos-performance
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED
P2X0-1030-09ENZ0
351
When the port number is specified (the host affinity mode is disabled):
# CM#0 CA#0 Port#1 Port Performance Information
A
# Port Type FC
B
# Host Affinity Disable
C
# Performance Monitoring OFF
D
# Monitoring Start Time 2012-04-11 12:00:00
E
# Monitoring Stop Time 2012-04-11 12:05:00
F
# IOPS Throughput(MB/s) Delay Time(ms)
# Ave Min Max Ave Min Max Total Ave
# Port Total 111000 110 222000 20 10 30 1000 10
G H I J K L M N
# IOPS Throughput(MB/s) Delay Time(ms)
# LUN Ave Min Max Ave Min Max Total Ave
# 1 20 10 100 2 1 3 20 10
# 1021 60 11 30 2 1 2 120 10
O P Q R S T U V W
A:
Host interface port number
B:
Port type
C:
Host affinity (Enable: enabled, Disable: disable)
D:
Measurement status (ON: performance is being measured, OFF: performance measuring is stopped)
E:
Performance measurement start time
F:
Performance measurement stop time
G:
Average number of I/Os per second for a port
H:
Minimum number of I/Os per second for a port
I:
Maximum number of I/Os per second for a port
J:
Average transfer amount per second for a port (in MB/s)
K:
Minimum transfer amount per second for a port (in MB/s)
L:
Maximum transfer amount per second for a port (in MB/s)
M:
Accumulated delay time since the start of a command from the QoS control of a port (in milliseconds)
"Overflow" is displayed when a long time passes from the start of performance measurement to the end of
performance measurement and the accumulated delay time exceeds the limit.
N:
Average delay time for a single command from the QoS control of a port (in milliseconds)
O:
LUN number
P:
Average number of I/Os per second for a LUN
Q:
Minimum number of I/Os per second for a LUN
R:
Maximum number of I/Os per second for a LUN
S:
Average transfer amount per second for a LUN (in MB/s)
T:
Minimum transfer amount per second for a LUN (in MB/s)
U:
Maximum transfer amount per second for a LUN (in MB/s)
V:
Accumulated delay time since the start of a command from the QoS control of a LUN (in milliseconds)
"Overflow" is displayed when a long time passes from the start of performance measurement to the end of
performance measurement and the accumulated delay time exceeds the limit.
W:
Average delay time for a single command from the QoS control of a LUN (in milliseconds)
Summary of Contents for Eternus DX410 S2
Page 2: ...This page is intentionally left blank ...
Page 756: ......
