Chapter 4 Function/System Settings and Display
4.1 User Management > show radius
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED
P2X0-1030-09ENZ0
376
show radius
This command displays the settings of the RADIUS server.
■
Syntax
■
Parameter
No parameters.
■
Output
show radius
# RADIUS authentication [Enable]
A
# After error [No]
B
# Primary server [10.21.134.198]
C
# Primary port [MNT]
D
# Primary port number [1812]
E
# Primary authentication mode [CHAP]
F
# Primary shared secret [xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx]
G
# Primary retry timeout [20]
H
# Secondary server [10.17.80.6]
I
# Secondary port [RMT]
J
# Secondary port number [1912]
K
# Secondary authentication mode [PAP]
L
# Secondary shared secret [yyyyyyyyyyyyyyyyyyyyyyyyyyyyyyyy]
M
# Secondary retry timeout [20]
N
A:
Mode. Display the system's mode.
B:
Displays which method used after found error.
C:
FQDN or IP address (IPv4 or IPv6) of the primary authentication server.
D:
Port that is used for primary settings.
E:
Port number of the primary authentication server for the authentication protocol.
F:
Authentication method type of the primary authentication server.
G:
Shared secret of the primary authentication server.
H:
Retry timeout value of the primary authentication server.
I:
FQDN or IP address (IPv4 or IPv6) of the secondary authentication server
J:
Port that is used for secondary settings.
K:
Port number of the secondary authentication server for the authentication protocol.
L:
Authentication method type of the secondary authentication server.
M:
Shared secret of the secondary authentication server.
N:
Retry timeout value of the primary authentication server.
Summary of Contents for Eternus DX410 S2
Page 2: ...This page is intentionally left blank ...
Page 756: ......
