Chapter 4 Function/System Settings and Display
4.2 Advanced Copy Management
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED
P2X0-1030-09ENZ0
383
4.2.2.3
Operation settings
■
Operation policy setup
Set the threshold for notification of SDPV overflow that may occur during copy operations and the action of the
notification.
[Example]
Setting for notification of "information", "warning", and "error" if up to 60% and 80%, and more than 95% of
the SDPV capacity is used respectively.
[Example]
Set whether to send a notification for each threshold with an e-mail message (or SNMP) or not.
4.2.3
Copy Session Management
4.2.3.1
Copy management
After preparation for Advanced Copy is complete, create a copy session to start copying volumes. During
operation, also check the status of the copy sessions and delete unnecessary copy sessions.
■
copy execution
Create a copy session by using the "start advanced-copy" command to start the copy.
[Example]
Starting the copy from the copy source volume#0 to copy destination volume (SDV) #100.
CLI> set advanced-copy-policy -level information -threshold 60
CLI> set advanced-copy-policy -level warning -threshold 80
CLI> set advanced-copy-policy -level error -threshold 95
CLI> set event-notification -level i-sdp-policy-information -target email -suppression disable
CLI> start advanced-copy -source-volume-number 0 -destination-volume-number 100
Summary of Contents for Eternus DX410 S2
Page 2: ...This page is intentionally left blank ...
Page 756: ......
