Chapter 4 Function/System Settings and Display
4.2 Advanced Copy Management > show advanced-copy-sessions
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED
P2X0-1030-09ENZ0
405
■
Copy session error codes
X:
The split mode of the relevant session is displayed only when the type REC is selected.
Automatic: A mode in which Write I/O accesses to copy source are accepted when the copy path of REC is in
abnormal status.
Manual: A mode in which Write I/O accesses to copy source are accepted when the copy path of REC is in
abnormal status. Specified sense information is sent to the host.
Y:
The session ID of another which is remotely connected with this system is displayed.
Z:
The identifier of another which is remotely connected with this system is displayed.
a:
Time stamp is displayed in local time.
The previous time stamp backed-up is displayed when the Status is Active or Suspend.
The time that the accident occurred is displayed when the Status is Error Suspend or Halt.
b:
The elapsed time from starting the session is displayed (unit: day, hour, min, sec).
c:
The resolution of the session is displayed (x2, x4, x8, x16).
d:
The license information of the session is displayed (Regular, Trial, Unknown).
e:
The copy range is displayed. (Totally, Extent)
f:
It indicates whether the Secondary area can be accessed when the Status is Active. (Read Only at Equivalency,
No Read/Write)
g:
It indicates the transition status of Concurrent Suspend. (Normal, Exec, Error, Unknown)
h:
It indicates the execution result of the Change command. (Normal, Mode Change Error, Reverse Error)
i:
It indicates the estimated time until the transition to Suspend status is complete.
Error code
Description
0x10 – 0x1F
An error that is caused by a copy source volume occurs. Some copy source volumes can-
not be accessed because a failure has occurred in a component (e.g. drives and drive
enclosures).
0x20 – 0x2F
An error that is caused by a copy destination volume occurs. Some copy destination vol-
umes cannot be accessed because a failure has occurred in a component (e.g. drives
and drive enclosures).
0x30 – 0x3F
An error that occurs due to a path.
0xBA
Bad data exists.
0xBB
SDV/SDP capacity is insufficient.
0xBD
Overload status is detected in a copy destination volume or a copy destination storage
system.
0xBE
A line has failed. Data is stored in the REC Buffer. This error is displayed only when the
"Type" is "REC".
0xBF
A line has failed. Data is stored in the REC Disk Buffer. This error is displayed only when
the "Type" is "REC".
Error codes other than above
An error other than the ones listed above occurs.
Summary of Contents for Eternus DX410 S2
Page 2: ...This page is intentionally left blank ...
Page 756: ......
