Chapter 4 Function/System Settings and Display
4.4 Miscellaneous > set encryption
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED
P2X0-1030-09ENZ0
565
set encryption
This command specifies whether encryption mode is enabled or disabled. When the encryption mode is
enabled, "Fujitsu" or "AES" should be specified as the kind of encryption. After switching the encryption mode
from enabled to disabled, the ETERNUS DX Disk storage system power must be turned off and back on again
to apply the setting. When switching the encryption mode from disabled to enabled, this operation is not
required.
■
Syntax
■
Parameter
■
Example(s)
Encryption-related functions may not be available for some user environments.
set encryption -mode {fujitsu | aes | disable}
-mode
This parameter specifies encryption mode.
fujitsu
Encryption mode is enabled. (Fujitsu)
aes
Encryption mode is enabled. (AES)
disable
Encryption mode is disabled.
The following example enables the Fujitsu encryption mode function:
CLI> set encryption -mode fujitsu
The following example disables the encryption mode functions,
and then reboots the ETERNUS DX Disk storage system to apply the setting:
CLI> set encryption -mode disable
CLI> shutdown -mode reboot
Summary of Contents for Eternus DX410 S2
Page 2: ...This page is intentionally left blank ...
Page 756: ......
