ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED
P2X0-1030-09ENZ0
18
Chapter 1
Overview
ETERNUS DX Disk storage system command line interface (hereinafter referred to as "CLI") is installed in
controllers of the ETERNUS DX Disk storage system. CLI is used for performing settings and maintenance via
commands and command scripts.
This chapter describes the outlines for the CLI.
1.1
Accessing CLI
The CLI software embedded in each ETERNUS DX Disk storage system controller module enables storage
systems to be configured, monitored, and managed. This may be done via LAN connection to the controller
module's Ethernet port, using telnet, an SSH application, or a terminal emulator on a remote administrator
client. For telnet connection, a user name and password are required. For SSH, in addition to a user name and
password, SSH public key authentication is also supported. For details, refer to the "import ssh-public-key"
command.
Default IP address, user name, and password are as follows:
CLI will display the following pre-login message on the terminal:
The date and time are the local values. However, this message may not be displayed when logged in with
SSH. This is due to the fact it depends on terminal software.
IP address:
192.168.1.1
user name:
root
password:
root
ETERNUS login is required. [2010-01-01 05:38:00]
Summary of Contents for Eternus DX410 S2
Page 2: ...This page is intentionally left blank ...
Page 756: ......
