Chapter 5 Servicing the Tape Library
5.6 Replacing a Redundant Power Supply
FUJITSU Storage ETERNUS LT40 S2/LT60 S2 LTO Library Installing, Starting Up and Maintaining
Copyright 2018 FUJITSU LIMITED
P3AM-5392-07ENZ0
91
■
Replacing the power supply
Procedure
1
Unpack the new power supply from its package.
2
Slowly insert the new power supply into the bay, and align the connectors on the library
while supporting the power supply assembly.
3
Tighten the captive thumbscrews until the power supply is secure.
4
Replace the power cord cable.
5
Switch on power to the library (power button on the front panel).
End of procedure
5.6
Replacing a Redundant Power Supply
Figure 5.8 Replacing a redundant power supply
Procedure
1
Loosen the three screws on the library see
, step 1).
2
Unpack the redundant power supply from its package.
3
Slowly insert the new power supply into the bay (see
, step 2),
4
and align the connectors on the library while supporting the power supply assembly.
The second power supply can be installed without powering down the library.
Summary of Contents for ETERNUS LT40 S2
Page 2: ...This page is intentionally left blank ...
Page 110: ......