Chapter 11 System Management
11.2 Functions in the Action Area for System
ETERNUS Web GUI User’s Guide
477
Copyright 2011 FUJITSU LIMITED
P2X0-1090-02ENZ0
6
Click the [OK] button.
→
Setting of the SNMP Agent community starts.
7
Click the [Done] button to return to the [Network] screen.
End of procedure
11.2.3.8
Setup SNMP Agent Trap
This function notifies events that occur in the ETERNUS DX Disk storage system to the SNMP
Agent Manager by an SNMP Trap.
This function configures the trap destination, the trap version, etc.
Up to ten traps can be specified for each ETERNUS DX Disk storage system.
The procedure to set the SNMP Agent trap is as follows:
Procedure
1
Click [Setup SNMP Trap] in [Action].
•
If the "SNMP Function" is disabled, the [Setup SNMP Agent Manager]
function cannot be used.
•
When SNMP Agent Manager exists in a different subnetwork from
where the ETERNUS DX Disk storage system belongs, specify the IP
address or the network address of SNMP Agent Manager in the
"Allowed IP List" using the procedure in
