Chapter 2 Setup
>
2.3 Setting Items
ETERNUS Disk storage systems ETERNUSmgr User Guide -Introduction-
22
Copyright 2009 FUJITSU LIMITED
P2X0-0202-04ENZ0
[Example]
BUSY_TIME=1800
2.3.2
E-mail Notification Settings
This section explains how to setup the E-mail notification function. See
"6.3 E-mail Messages"
(page 54)
for the content of E-mail messages provided by this function.
■
Admin Mail Address
This parameter is used to specify an address to which to send the E-mail generated in the event
of change in the target device status. Usually this is the address of the target device administra-
tor.
The E-mail notification function is disabled if this parameter is omitted.
[Parameter]
ADMIN_MAIL (up to 64 characters)
[Example]
ADMIN_MAIL=admin@domain-name.com
To set multiple E-mail addresses, use a comma with no spaces between each address.
ADMIN_MAIL=admin1@domain-name.com,admin2@domain-name.com
■
Alarm Mailing Interval
This parameter is used to specify the interval for sending generated E-mail in the event of a fail-
ure or abnormality in the machine. Units are seconds.
Set the interval in units of seconds within the range of 1 ~ 65535. Set this parameter only if you
wish to send E-mail with timing different from the specified Polling Interval. For example, by set-
ting this parameter, you can set a short Polling Interval and long Alarm Mailing Interval. This will
allow any device errors that may have occurred over this interval to be collected and sent
together with other E-mail messages.
This parameter is not a required setting. If omitted, the default value will be the same as the
Polling Interval.
[Parameter]
MAIL_SEND_TIME (1-65535)
[Example]
MAIL_SEND_TIME=300
This specifies the Alarm Mailing Interval (time between the sending of one notification E-mail
message to the next) for sending E-mail.
Due to network or device load the time to send the E-mail may exceed the expected time. In such
cases, the E-mail sending times are recalculated the same way as for the polling time.
This setting is not described in the initial setup file. Add if necessary.
This setting needs not be changed.
