7
5. Click [INSTALL], and then click [ISIS Driver].
6. Error Recovery Guide Installation dialog box
appears.
Error Recovery Guide is an application with
which you can view on-screen information for
troubleshooting errors that may occur in the
scanner. This guide helps solve problems, so
select [Yes] to install it. You may also choose
to install it later.
7. Select a language for the installation on the
[Choose Setup Language] dialog box, and then
click the [Next] button.
8. Install the driver, following the on-screen
instructions.
9. When you see the [InstallShield Wizard Com-
plete] dialog box, click the [Finish] button.
Your computer will restart and detect the scanner. Do
not remove the Setup DVD-ROM from the DVD drive
until your personal computer completely starts up again.
Software Operation Panel
You can configure settings related to scanning and man-
age consumables using the Software Operation Panel. It
is installed together with TWAIN driver/ISIS driver.
Error Recovery Guide
Error Recovery Guide is a software that displays trou-
bleshooting information on screen if any scanner error
occurs.
If you did not install together the Error Recovery Guide
with the driver, please proceed with the procedures
given below for installing it.
1. Insert the Setup DVD-ROM into the DVD drive.
⇒
<SETUP DICS STARTUP SCREEN> appears.
2. Click [INSTALL].
3. Click [Error Recovery Guide] on the next
screen.
4. Select a language to use for the installation in
the <Choose Setup Language> window and
click [OK].
5. Install the application following the instructions
in the window.
6. When the [InstallShield Wizard Complete]
screen displays, click [Finish].
ATTENTION
After you select [Yes] for installing Error
Recovery Guide, the [Choose Setup Lan-
guage] dialog box appears. Select a lan-
guage and follow the on-screen
instructions. The Error Recovery Guide
dialog box is automatically displayed when
the installation is complete. Wait until the
installation of the ISIS starts.
ATTENTION
Depending on the operating system you
are using, you may need to do the follow-
ing.
Windows 2000:
If you see the [Digital Signature not
Found] dialog box, click [Yes].
Windows Vista:
If you see the [Found New Hardware] dia-
log box, select [Locate and install driver
software], and then in the [User Account
Control] dialog box, click the [Continue]
button, if it is displayed.
