fi-5530C2 Image Scanner Operator’s Guide
xiii
CAUTION
Do not install the scanner on unstable surfaces.
Do not block the ventilation ports.
Do not place heavy objects or stand on top of the scanner.
Firmly insert the power plug.
Avoid any contact when scanner is in use.
Do not use the scanner immediately after moving it from a cold
place into a warm room.
Make sure that the scanner is installed on a flat, level surface and that none of its parts
extend beyond the surface top, such as a desk or table. Do not install the scanner on
unstable surfaces. Install the scanner on a level surface that is free of vibration to
prevent it from falling.
Install the scanner on a strong surface that will support the weight of the scanner and
other devices.
Do not block the ventilation ports. Blocking the ventilation ports generates heat inside of
scanner, which may results in fire or scanner failure.
Do not place heavy objects on the scanner or use the scanner's surface top to perform
other work. Improper installation might cause injuries and equipment failure.
Firmly insert the power plug as far it can go into the power outlet.
Avoid touching any scanner mechanism during scanning since this may cause injuries.
Do not use the device immediately after moving it from a cold place into a warm room.
This may cause condensation, which might lead to scanning errors. Let the device dry
about one or two hours before you use it.
Summary of Contents for FI-5530C2
