Chapter 1 Scanner Overview
19
Power saving mode keeps the power consumption low when
the scanner has not been used for a certain period of time.
If the scanner is left powered on for 15 minutes without being
used, it automatically enters power saving mode.
When the scanner enters power saving mode, the [Power]
button flashes green.
To resume from power saving mode, perform either of the
following:
Press the [Power] button on the operator panel.
Note that pressing the [Power] button for more than 2 seconds will
turn the power off.
Perform scanning from an application.
The scanner is turned off automatically if it is left on for a
certain period of time without being used, reducing the power
consumption until the next scan.
To prevent the scanner from being turned off automatically,
clear the [Power off after a certain period of time] check box in
[Device Setting] on the Software Operation Panel. For details,
refer to
"Waiting Time to Enter Power Saving Mode [Power
To turn the power back on after turning the power off
automatically, press the [Power] button on the operator panel.
For details, refer to
"1.3 Turning the Power ON/OFF" (page
1.5 Power Saving Mode
ATTENTION
When this scanner enters power saving mode or resumes from
power saving mode, the scanner that is linked with this scanner also
enters or resumes from power saving mode.
When the scanner performs scanning for the first time after it
resumes from power saving mode, the scanner performs
initialization similar to that performed at power-on.
For some applications, the scanner may not be turned off even if the
[Power off after a certain period of time] check box is selected.
If the scanner is automatically turned off while you are using the
image scanning application, exit the application before turning the
power on.
HINT
By using the Software Operation Panel, the waiting time for entering
power saving mode can be changed.
For details, refer to
"Waiting Time to Enter Power Saving Mode
For details about the operator panel, refer to
