7.5 Multifeed Detection Conditions
fi-6140 / fi-6240 Image Scanner Operator's Guide
7.5 Multifeed Detection Conditions
There are three multifeed detection modes: document overlapping, document length, and both document thickness
and length. The following conditions must be satisfied in each of these detection modes.
Detection by Document Overlapping
Sheets of the same thickness shall be set in the ADF at a time.
●
Document thickness: 0.05 to 0.26 mm
●
Punched holes are not allowed within 35 mm (1.38 in) of the vertical center line of the document.
●
Other paper shall not be glued within 35 mm (1.38 in) of the vertical center line of the document.
Detection by Document Length
Sheets of the same length shall be set in the ADF at a time.
●
Document length deviation: 1% or less
●
Punched holes are not allowed within 35 mm of the vertical center line of the document.
Detection by Document Overlapping and Length
Sheets of the same thickness and length shall be set in the ADF at a time.
●
Document thickness: 0.05 to 0.26 mm
●
Document length deviation: 1% or less
●
Punched holes are not allowed within 35 mm (1.38 in) of the vertical center line of the document.
●
Other paper shall not be glued within 35 mm (1.38 in) of the vertical center line of the document.
ATTENTION
Multifeed detection by overlap will often mis-detect very thick paper or plastic document.
When scanning documents like this, disable the multifeed detection.
HINT
The type of document and document conditions sometimes cause the multifeed detection
rate to drop.
The multifeed detection is not availabe in the area about 30 mm from the leading edge of
the document.
Multifeed detection monitoring area
file:////10.232.227.50/Manual/fi-6140_6240C-Lynx3/OG/R02/02_081030/contents/EN/07/c07_05_01.htm (1/2) [2008/10/30 12:42:36]
