Chapter 4 Various Ways to Scan
80
*1: When the paper separation force is set to [
] which is the
maximum level, the part of the message “When [Ready] is displayed,
increase the paper separation force by using the [
] button to
suppress multifeeds.” does not appear.
2
Place the removed document back on the hopper.
If a multifeed error is detected while no paper is attached on the
document, press the [Scan] button or restart scanning via the
computer (do not press the [iMFF] button). If there is a paper
attachment on the ejected sheet and the attachment is likely to be the
cause of the multifeed error, then proceed to the next step.
3
Press the [iMFF] button and confirm that
is displayed on
the LCD, and then press the [Scan] button or restart scanning
from the computer.
Note that, from hereon,
in the LCD switches between shown/
hidden every time the [iMFF] button is pressed. According to the
mode specified, the scanner operates as explained below if
documents are scanned while
is displayed.
Manual mode (Bypass by front panel button)
The next sheet is scanned without multifeed detection, and after
the second sheet, multifeed errors are detected based on the
settings configured in the scanner driver or the Software Operation
Panel.
Auto mode 1 (Bypass by combination of length and position)
The scanner memorizes the length and location of the paper
(overlap pattern) that caused a multifeed error and continues
scanning. When a paper attachment of a similar pattern is
detected, the scanner automatically ignores it to suppress
multifeed detection. (*1)(*2)
Auto mode 2 (Bypass by length)
The scanner remembers the length of the paper (overlap pattern)
that caused a multifeed error and continues scanning. When a
paper attachment of the same length or shorter is detected, the
scanner automatically ignores it to suppress multifeed detection.
(*2)
*1: Up to eight overlap patterns can be memorized in this mode.
When the 9th overlap pattern is detected, the first pattern
that was memorized is erased from the memory.
*2: To erase the memorized overlap patterns and the longest
overlap length, press the [iMFF] and [Counter Reset]
buttons at the same time for more than two seconds while
[Ready] is displayed on the LCD. The LCD will display
or
when the memory is erased. This
allows you to erase multifeed patterns and the longest
overlap length that were not supposed to be memorized. Be
careful with this operation because all memorized patterns
will be erased.
Multifeed patterns can also be erased from the Software
Operation Panel or [1: iMFF Setting] in the [Main Menu] of
the operator panel.
If you click the [OK] button in the window that shows the
multifeed image, step
is not required because the scanner
feeds the multifeed image and continues the scan.
Function
/Enter
Check
Menu
Scan
Stop
Eject
Counter
Reset
iMFF
Send to
/Pause
Clear
/Back
LCD
[Scan] Button
[Eject] Button
[iMFF] Button
