Chapter 5 Daily Care
89
Scan Glass
Clean it lightly.
Paper path upper-side (glasses: 2 sheets)
The glass should not have to be removed as it is designed
to block paper dust. Remove and clean the glass only if
the scanner is being used in an environment with large
amounts of paper dust and vertical streaks appear on the
scanned image even after cleaning the glass. Be careful
not to let any paper dust in when removing the glass.
Clean the glass on paper path upper-side as follows:
1 Loosen the screw until the glass can be lifted.
2 Tilt the glass to the angle as shown above.
3 Remove the glass as you slide it to the right.
Glass (removable)
Glass (not removable)
2
1
3
4 Clean the removed glass.
5 From the gap where the glass was attached, clean
the other layer of glass inside, using a cotton swab or
something alike.
Vertical streaks may appear on the scanned image when
the glass is dirty.
Cross-section
Glass
