50
<Drawer connection 1>
Notes:
1. Use a shielded drawer cable.
2. Two drives cannot be driven simultaneously.
3. The drawer on/off time must be specified using t1 and t2 in
the pulse generation command (ESC p m t1 t2).
4. The drawer drive duty must be as follows:
ON-time/(ON-time + OFF-time)
≤
0.2
5. The drawer power must always be supplied from the printer
power supply unit via connector pin 4.
6. The resistance of the drawer kick solenoid must be at least 24
Ω
.
If a solenoid with a lower resistance is used, the solenoid might
be destroyed by over current.
APPENDIX
Printer
2
3
4
5
6
Cable
Drawer
3
4
5
6
2
Drawer kick solenoid
(24
Ω
minimum)
Drawer
open/close
switch
1
1