162
CHAPTER 8 16-BIT RELOAD TIMER
■
Notes
•
The internal prescaler is enabled if a trigger (soft trigger or external trigger) is applied when bit1 (timer
enable: CNTE) of the control status register is set to "1".
•
If the device attempts to set and clear the interrupt request flag at the same time, the flag is set
preferentially and the clear operation becomes ineffective.
•
If the device attempts to write to the 16-bit reload timer register and reload the data into the 16-bit
reload timer register at the same time, old data is loaded into the counter. New data is loaded into the
counter at the next reload timing.
•
If the device attempts to load and count the 16-bit timer register at the same time, the load (reload)
operation takes precedence.
Summary of Contents for FR60Lite
