267
CHAPTER 11 MULTIFUNCTIONAL TIMER
11.6.2
Operation of 16-bit Output Compare
Output compare is used to compare the value set in the compare clear register with the
16-bit free-run timer value. If a match is detected, the interrupt flag is set, and the output
level is reversed.
Match signals are ignored by the free-run timer when compare register value matches
with the count peak value of the free-run timer.
■
Operation of 16-bit Output Compare (Inverted Mode, MOD1x=0)
●
Compare operation can be performed on each channel (compare control register higher-order
(OCSH1, OCSH3, and OCSH5) CMOD: bit12 = 0).
Figure 11.6-11 Example of Output Waveform if Compare Registers 0 and 1 are Used Separately when the
Initial Value of Output Is "0" (Free-run Timer Is Up Count Mode)
Comp
a
re regi
s
ter 0
BFFF
H
Comp
a
re regi
s
ter 1
7FFF
H
RT0
RT1
Comp
a
re 0 interr
u
pt
Comp
a
re 1 interr
u
pt
Re
s
et
Time
7FFF
H
FFFF
H
BFFF
H
3
FFF
H
0000
H
Co
u
nt v
a
l
u
e
Summary of Contents for FR60Lite
