329
CHAPTER 14 8/10-BIT A/D CONVERTER
■
Block Diagram of 8/10-bit A/D Converter Pin
Figure 14.3-1 Block Diagram of AN0 to AN11 Pins
Notes:
•
Set the DDR register bits corresponding to the pins to be used as input ports to "0" and apply pull-
up resistance to the external pins. Also, set the bits corresponding to the AICR register to "0".
•
Set the AICR register bit corresponding to the pin to be used as the analog input pin to "1". When
this is done, the value "0" will be read from the PDR register.
AICR0,1,2
PDR (port data register)
PDR read
PDR write
Output latch
DDR read
DDR write
Direction latch
DDR (port direction register)
Pin
Standby control
Analog input
Inter
nal b
us data
Summary of Contents for FR60Lite
