429
CHAPTER 17 FLASH MEMORY
■
Temporary Sector Protect Cancel
Once a sector is protected by enable sector protect, write/erase operations are disabled unless it breaks
down. However, the temporary sector protect cancel operation can cancel the protection information in the
protected sector temporarily. This operation is set by keeping an application of V
ID
to MD1. In this
period, the sector protection information that is set before is ignored, and so write/erase operations can be
performed in all sectors. When MD1 returns to "1" (=3.3 V), this operation is canceled and all sectors
protected before are protected again. Figure 17.6-2 shows the temporary sector protect cancel algorithm.
Figure 17.6-2 Temporary Sector Protect Cancel Algorithm
Start
MD1=VID
*1
Execute erase or write operations
MD1="H"
Sector protect cancellation end
*2
*1: The protection of all protected sectors is
cancelled.
*2: Sectors protected before are protected
again.
Summary of Contents for FR60Lite
