433
CHAPTER 18 SERIAL PROGRAMMING CONNECTION
■
Pins Used for Fujitsu Standard Serial Onboard Writing
Notes:
•
To use the P44, P45, SIN0, SOT0, and SCK0 pins within the user system as well, the control
circuit shown in the following figure is required.
(Using the flash microcontroller programmer’s /TICS signal, the user circuit can be disconnected
in serial programming mode.)
•
Connect with AF200 under the power-off state of the user power supply.
Pin
Function
Description
MD2, MD1, MD0 Mode pin
Control to set the flash serial programming mode.
Flash serial programming mode: MD2, MD1, MD0=1, 0, 0
Reference: Single-chip mode: MD2, MD1, MD0=0, 0, 0
P44, P45
Writing program start pin
Set "L" level to P44, and "H" level to P45.
INIT
Reset pin
–
SIN0
Serial data input pin
Use UART ch.0 resource as clock synchronous mode.
SOT0
Serial data output pin
SCK0
Serial clock input pin
V
CC
Power voltage supply pin
Supply programming voltage from the user system. When connecting,
do not short with power supply of the user side.
V
SS
GND pin
Must be shared with GND of the flash microcontroller programmer.
U
s
er circ
u
it
MB91F264B
write control pin
AF220/AF210/
AF120/AF110
/TIC
S
pin
AF220/AF210/
AF120/AF110
write control pin
Summary of Contents for FR60Lite
