219
8.27 Paper Stop Position at Multifeed Error
8
SCANNER SETTINGS
8.27 Paper Stop Position at Multifeed
Error
When a multifeed error is detected by overlapping of documents, the position to stop the documents on
which the multifeed occurred can be selected.
To configure this setting, [Check by overlapping (US sensor)] must be specified for multifeed detection
(
“8.4 Multifeed Detection” on page 190
Configure the settings for Paper Stop Position at Multifeed Error as follows.
1.
Start up the Software Operation Panel.
“8.1 Scanner Settings” on page 173
.
2.
Select [Device Setting 2] from left side list in the window, and select
[Paper stop position at multifeed error] from its lower level.
3.
Select one of the following modes and click the [OK] button.
Normal
: Stops feeding when a multifeed error is detected by overlapping.
Paper output slot
: Feeds the documents to the Paper output slot and stops when a multi-
feed error is detected by overlapping.
This setting makes it easier to identify on which document a multifeed
error occurred.
Summary of Contents for Fujitsu fi-5950
