Fujitsu LifeBook A6025 User Manual Download

Page: 61 / 120

T r o u b l e s h o o t i n g

Your notebook appears to
change setup parameters
when you start it.

(continued)

The BIOS CMOS hold-up
battery has failed.

Contact your support representative for repairs.
This is not a user serviceable part but has a normal
life of 3 to 5 years.

Video Problems

The built-in display is blank
when you turn on your
LifeBook notebook.

Something is pushing on the
Closed Cover switch.

Clear the Closed Cover switch.

(See figure 2-3 on

page 6 for location)

The notebook is set for an
external monitor only.

Pressing [F10] while holding down the [Fn] key
allows you to change your selection of where to send
your display video. Each time you press the keys you
will step to the next choice. The choices, in order,
are: built-in display panel only, both built-in display
panel and external monitor or external monitor
only.

The display angle and bright-
ness settings are not adequate
for your lighting conditions.

Move the display and the brightness control until
you have adequate visibility.

The power management time-
outs may be set for very short
intervals and you failed to
notice the display come on
and go off again.

Press any button the keyboard, or move the mouse
to restore operation. If that fails, push the Power/
Suspend/Resume button. (The display may be shut
off by Sleep mode, Auto Suspend or Video Timeout)

The notebook turned on
with a series of beeps and
your display is blank.

Power On Self Test (POST) has
detected a failure that does not
allow the display to operate.

Contact your support representative.

The display goes blank by
itself after you have been
using it.

The notebook has gone into
Video timeout, Sleep mode, or
Hibernate mode because you
have not used it for a period of
time.

Press any button on the keyboard, or move the mouse
to restore operation. If that fails, push the Power/
Suspend/Resume button. Check your power manage-
ment settings, or close your applications and go to the
Power Options control panel.

The power management time-
outs may be set for very short
intervals and you failed to
notice the display come on
and go off again.

Press any button on the keyboard, or move the mouse
to restore operation. If that fails, push the Power/
Suspend/Resume button. (The display may be shut
off by Sleep Mode, Auto Suspend or Video
Timeout).

The display does not close.

A foreign object, such as a
paper clip, is stuck between the
display and the keyboard.

Remove all foreign objects from the keyboard.

The display has bright or
dark spots.

If the spots are very tiny and
few in number, this is normal
for a large LCD display.

This is normal; do nothing.

If the spots are numerous or
large enough to interfere with
your operation needs.

Display is faulty; contact your support representative.

The display is dark when on
battery power.

The Power Management utility
default is set on low brightness
to conserve power.

Press [Fn] + [F7] to increase brightness or right-
click on the battery gauge and adjust the Power
Options.

Problem