Fujitsu LifeBook B2630 User Manual Download

Page: 99 / 114

W I r e l e s s L A N U s e r ’ s G u i d e

4. Perform the following steps.

■

Click [Internet Protocol (TCP/IP)].

■

Click [Properties]. The [Internet Protocol (TCP/IP)
Properties] window appears.

5. Set an IP address as indicated in Table 10. Ask your

network administrator to check the setting.

Table 10: Setting an IP Address

6. Click [OK]. The [Local Area Connection Properties]

window appears again.

7. Click [OK]. When a message appears prompting you

to restart the computer, click [Yes].

Checking the full computer name and workgroup

1. Click [Start] -> [Settings] -> [Control Panel].

2. Double-click the [System] icon. [System Properties]

appears.

3. Click the [Network Identification] tab.

4. Check [Full computer name] and [Workgroup]. Ask

your network administrator and check the setting.

Table 11: Checking computer name and workgroup

5. Click [OK]. When a message appears prompting you

to restart the computer, click [Yes].

Sharing

In this section, you set sharing of the drive, folder, and
printer.

You only need to set this when you are sharing files or a
printer with other computers on the network.

When you share a drive, folder, or printer, you can use
them from any computer on the network.

Setting [File and Printer Sharing for Microsoft
Networks]

1. Click [Start] -> [Settings] -> [Control Panel].

2. Double-click the [Network and Dial-up

Connections] icon. The [Network and Dial-up
Connections] windows appears.

3. Right click the [Local Area Connection], then click

[Properties] from the menu that appears. [Local

Area Connection Properties] appears.

4. If [File and Printer Sharing for Microsoft Networks]

is displayed in the list, make sure that it is checked. If
it is not checked, check it and click [OK]. You do not
have to perform the following steps. Go to the next
section, entitled “Sharing Files.”

If [File and Printer Sharing for Microsoft Networks]
is

not

found in the list, click [Install], and perform

Step 5 and subsequent steps. When you click

Item

Description

For AdHoc
Network

Set the IP address and subnet mask:

Click [Use the following IP address],
and enter a value for [IP address] and
[Subnet mask].

Refer to “Setting IP Addresses” on
page 102 to set an IP address and
subnet mask.

For
Infrastructure
Network

Select [Obtain an IP address
automatically]:

For the DNS server, select [Obtain
DNS server address automatically].

For the IP address, DNS server, and
default gateway, follow the network
administrator's instructions, if any.

Item

Description

Full
Computer
Name

A name to identify the computer on
the network. You can specify any
name to each computer.

For easier identification, use the model
name or user name.

Workgroup

A name for the network group:

■

AdHoc Network:
Specify the same name to all com-
puters within the same network.

■

Infrastructure Network: Specify a
workgroup name to connect to.

To change the setting, click
[Properties], and follow the instruc-
tions on the screen. [System Proper-
ties] appears again.

P O I N T

More than one network adapter is installed in your
system if more than one [Local Area Connection] entry
is displayed. In this case, select the [Local Area Connec-
tion] entry with [Intersil PRISM Wireless LAN PCI Card]
displayed under [Device Name].

Item

Description

B Series.book Page 93 Tuesday, March 25, 2003 5:29 PM