Fujitsu LifeBook C-4235 User Manual Download

Page: 3 / 113

L i f e B o o k C S e r i e s

FCC NOTICES
Notice to Users of Radios and Television

These limits are designed to provide reasonable protec-
tion against harmful interference in a residential installa-
tion. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a partic-
ular installation. If this equipment does cause harmful
interference to radio or television reception, which can
be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by
one or more of the following measures:

■

Reorient or relocate the receiving antenna.

■

Increase the separation between the equipment
and receiver.

■

Connect the equipment into an outlet that is on a
different circuit than the receiver.

■

Consult the dealer or an experienced radio/TV
technician for help.

Shielded interconnect cables must be employed with this
equipment to ensure compliance with the pertinent RF
emission limits governing this device.

Notice to Users of the US Telephone Network

Your Fujitsu LifeBook notebook may be supplied with
an internal modem which complies with Part 68 of the
FCC rules. On this notebook is a label that contains the
FCC Registration Number and the Ringer Equivalence
Number (REN) for this equipment among other infor-
mation. If requested, the user must provide their
telephone company with the following information:

1. The telephone number to which the notebook

is connected.

2. The Ringer Equivalence Number (REN) for

this equipment.

3. That the equipment requires a standard

modular jack type USOC RJ-11C which
is FCC Part 68 compliant.

4. The FCC Registration Number.

This equipment is designed to be connected to the tele-
phone network or premises wiring using a standard
modular jack type USOC RJ-11C which is FCC Part 68
compliant and a line cord between the modem and the
telephone network with a minimum of 26AWG.

The REN is used to determine the number of devices
that you may connect to your telephone line and still
have all of those devices ring when your number is
called. Too many devices on one line may result in
failure to ring in response to an incoming call. In most,
but not all, areas the sum of the RENs of all of the
devices should not exceed five (5).To be certain of
the number of devices you may connect to your line,
as determined by the RENs, contact your local
telephone company.

If this equipment causes harm to the telephone network,
your telephone company may discontinue your service
temporarily. If possible, they will notify you in advance.
If advance notice is not practical they will notify you as
soon as possible. You will also be advised of your right to
file a complaint with the FCC.

This fax modem also complies with fax branding
requirements per FCC Part 68.

Your telephone company will probably ask you to
disconnect this equipment from the telephone network
until the problem is corrected and you are sure that the
equipment is not malfunctioning. This equipment may
not be used on coin-operated telephones provided by
your telephone company. Connection to party lines is
subject to state tariffs. Contact your state’s public utility
commission, public service commission or corporation
commission for more information.

This equipment includes automatic dialing capability.
When programming and/or making test calls to
emergency numbers:

■

Remain on the line and briefly explain to the
dispatcher the reason for the call.

■

Perform such activities in off-peak hours, such
as early morning or late evening.

FCC rules prohibit the use of non-hearing aid compatible
telephones in the following locations or applications:

■

All public or semipublic coin-operated or credit
card telephones.

C A U T I O N

Changes or modifications not expressly approved by
Fujitsu PC Corporation could void this user’s authority
to operate the equipment.