Fujitsu Lifebook E2010 User Manual Download

Page: 109 / 124

103

W I r e l e s s L A N U s e r ’ s G u i d e

Table 7: Checking connectivity

CONNECTING WINDOWS XP SYSTEMS

This chapter describes how to set up the wireless LAN
connection for computers that are running Windows XP.

Workflow

The proper setup of the wireless LAN connection
requires that several steps be performed in the proper
order. Following is a general outline of the steps to be
performed. Each step is detailed later in this procedure.

1. Setting parameters

■

Setting the profile

■

Setting the encryption

2. Network settings

■

Setting the protocol and checking the network

■

Setting file and printer sharing

■

Checking the connection

Setting Parameters

1. Click [Start] -> [Control Panel].

2. Click [Network and Internet connection].

3. Click [Network connection]. A list of networks that

are currently installed is displayed.

4. Right click [Intersil PRISM Wireless LAN PCI Card]

in the list, and click [Properties] from the menu that
is displayed. [Wireless Network Connection 2 Prop-
erties] appears.

5. Click the [Wireless Networks] tab. The [Wireless

Networks] tab appears.

6. Perform the following steps.

■

Make sure that [Use Windows to configure my wire-
less network settings] is checked.

■

Click [Add] under [Preferred networks]. [Wireless
Network Properties] appears.

7. Set parameters.

■

For the AdHoc network, specify the same value to all
the computers, for which the encryption key is used
for connection.

■

For the infrastructure network, specify the encryp-
tion key (network key) with the same value to the
encryption key of the access point. For how to check

Item

Description

State

Shows the current condition of
connection.

The MAC address of the other
computer to which you are
connected is displayed when the
connection is successful. If you are
connected to more than one
computer, the computer that has
the best connectivity is displayed.

Current Channel

Shows the current channel used
for the connection.

Current Tx Rate

Shows the current transfer rate in
Mbits/sec.

[Radio Off]/
[Radio On]

Click [Radio Off] to disconnect.

Click [Radio On] to connect to the
network.

[Rescan] button

Click this button to search for
others to connect to.

Throughput
(Bytes/sec)

Shows the actual transfer rate of
the data transfer for send (Tx) and
receive (Rx).

Link Quality

Shows either [Excellent], [Good],
[Fair], [Poor], or [Not Connected],
depending on the link quality.

Not shown for AdHoc connection.

Signal Strength

Shows either [Excellent], [Good],
[Fair], [Poor], or [Not Connected],
depending on the signal strength.

Not shown for AdHoc connection.

P O I N T

If you purchased a LifeBook with the optional Wireless
LAN device, the integrated wireless LAN device and
drivers have already been installed. This procedure
outlines the steps for setting the device parameters.

Updated drivers and/or utilities may become available
after this manual is printed; see any addenda or fliers
that may be included in the system packaging.

B5FH-7511-01EN-00.book Page 103 Thursday, January 16, 2003 10:10 AM