Fujitsu LifeBook N3430 User Manual Download

Page: 95 / 112

R e g u l a t o r y I n f o r m a t i o n

Regulatory Information

NOTICE

Changes or modifications not expressly approved by
Fujitsu could void this user’s authority to operate the
equipment.

FCC NOTICES
Notice to Users of Radios and Television

These limits are designed to provide reasonable protec-
tion against harmful interference in a residential instal-
lation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a partic-
ular installation. If this equipment does cause harmful
interference to radio or television reception, which can
be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by
one or more of the following measures:

•

Reorient or relocate the receiving antenna.

•

Increase the separation between the equipment and
receiver.

•

Connect the equipment into an outlet that is on a
different circuit than the receiver.

•

Consult the dealer or an experienced radio/TV
technician for help.

Shielded interconnect cables must be employed with this
equipment to ensure compliance with the pertinent RF
emission limits governing this device.

Notice to Users of the US Telephone Network

This equipment (Agere Systems, Inc. Modem D40)
complies with Part 68 of the FCC rules, and the require-
ments adopted by ACTA. On the bottom of this equip-
ment is a label that contains, among other information,
the FCC registration number and ringer equivalence
number (REN) for this equipment; or a product identi-
fier in the format US:AAAEQ##TXXXX. If requested,
this information or number must be provided to the
telephone company.

This equipment is designed to be connected to the tele-
phone network or premises wiring using a standard jack
type USOC RJ11C. A plug and jack used to connect this
equipment to the premises wiring and telephone
network must comply with the applicable FCC Part 68
rules and requirements adopted by the ACTA. A
compliant telephone cord and modular plug is provided
with this product. It is designed to be connected to a
compatible modular jack that is also compliant.

The ringer equivalent number (REN) of this equipment
is 0.1B. The REN is used to determine the number of
devices that may be connected to a telephone line.

Excessive RENs on a telephone may result in the devices
not ringing in response to an incoming call. In most but
not all areas, the sum of RENs should not exceed five
(5.0). To be certain of the number of devices that may be
connected to a line, as determined by the total RENs,
contact the local telephone company. For products
approved after July 23, 2001, the REN for this product is
part of the product identifier that has the format
US:AAAEQ##TXXXX. The digits represented by ## are
the REN without a decimal point (e.g., 00 is a REN of
0.0). For earlier products, the REN is separately shown
on the label.

If this equipment causes harm to the telephone network,
the telephone company will notify you in advance that
temporary discontinuance of service may be required.
But if advance notice isn’t practical, the telephone
company will notify the customer as soon as possible.
Also, you will be advised of your right to file a complaint
with the FCC if you believe it is necessary.

The telephone company may make changes in its facili-
ties, equipment, operations or procedures that could
affect the operation of the equipment. If this happens,
the telephone company will provide advance notice in
order for you to make necessary modifications to main-
tain uninterrupted service.

If trouble is experienced with this equipment, for repair
or warranty information, please refer to the manual or
contact Fujitsu Computer Systems, Customer Service. If
the equipment is causing harm to the telephone
network, the telephone company may request that you
disconnect the equipment until the problem is resolved.

The equipment cannot be used on public coin service
provided by the telephone company. Connection to
party line service is subject to state tariffs. (Contact the
state public utility commission, public service commis-
sion or corporation commission for information).

If your home has specially wired alarm equipment
connected to the telephone line, ensure the installation
of this computer does not disable your alarm equip-
ment. If you have any questions about what will disable
alarm equipment, consult your telephone company or a
qualified installer.

The Telephone Consumer Protection Act of 1991 makes
it unlawful for any person to use a computer or other
electronic device to send any message via a telephone fax
machine unless such message clearly contains in a
margin at the top or bottom of each transmitted page or
on the first page of the transmission, the date and time it
is sent, and an identification of the business or other
entity, or other individual sending the message and the
telephone number of the sending machine or such
business, other entity, or individual.

N3430-02.book Page 87 Tuesday, May 16, 2006 10:48 AM