Removing and installing components during servicing
Installing and removing memory expansion
Memorymodule
Mainmemory
Removing memory
Systemexpansion
Systemexpansion
If you are asked by the Hotline/Service Desk to remove and install the memory
expansion yourself, proceed as follows:
Please observe the safety information in chapter
"Important notes", Page 12
.
When installing/removing memory modules, the battery must be removed from
the notebook and the notebook must not be connected to the power supply,
see
"Preparing to remove components", Page 53
.
Only use memory expansion modules that have been approved for your
notebook (see
"Technical data", Page 67
).
Never use force when installing or removing a memory extension.
Make sure that foreign objects do not fall into the memory extension compartment.
You must open the service compartment to remove or install a memory module. On some devices,
opening the compartment may expose other components. These components should be removed
and replaced only by authorised specialists. Therefore, be sure to observe the following:
Individual components can become very hot during operation. Therefore, we
recommend that you wait one hour after switching off the notebook before removing
or installing memory modules. Otherwise, there is a risk of suffering burns!
As some components are exposed that are sensitive to static electricity, please take
note of chapter
"Notes on installing and removing boards and components", Page 52
.
Removing memory modules
3
2
1
1
►
Carefully push the two mounting
clips outwards (1).
Memory expansion
Memory module
The memory module snaps upwards (2).
►
Pull the memory module out of its slot
in the direction of the arrow (3).
Fujitsu Technology Solutions
55
