71
- Memory Upgrade Module
Installing a Memory Module
1
Turn off power to your LifeBook notebook and
remove any power adapter.
2
Make sure that all the connector covers are
closed.
3
Turn the LifeBook notebook bottom side up, with
the front panel toward you.
4
Remove the screws at the front of the memory
upgrade module compartment.
(Figure 31)
5
Remove the cover by tilting the front edge up,
then pulling forward until the tabs on the cover
are free.
6
Remove the memory upgrade module from the
static guarded sleeve.
Figure 31. Opening the Memory Compartment
7
Align the memory upgrade module with the
component side up. Align the connector edge of
the memory upgrade module with the connector
slot in the compartment. The connector will be
pointing toward the rear of the notebook.
8
Insert the memory upgrade module at a 45°
angle. Press the connector edge of the module
firmly down and into the connector until it lodges
under the retaining clip. You will hear a click
when it is properly in place.
(Figure 32)
9
Replace the cover by hooking the tabs under the
rear edge of the compartment opening and
tilting down until flush with the bottom of your
notebook. Replace the screws.
Figure 32. Installing a Memory Upgrade Module
